Solid State Logic X-Logic, Owner'S Manual, Page: 16 / 58

Page 12
X-Rack Owner’s Manual
• The display will show ‘ 5a ’ and both the ‘ SAVE ’ LED and display flash.
• Create an additional MIDI track in your DAW program. Select its input and output to be the MIDI port
connected to your X-Rack.
• If available select the track to store System Exclusive data and record enable the MIDI track.
• Press Play and Record on the DAW to put the MIDI track into record.
• Press the
SAVE switch to start transmission of all saved Total Recall setups.
A ‘rotatingsegment’ display will start and run until all data has been transmitted
• Once the display changes to ‘ m1 ’ stop the DAW to end recording.
An unlimited number of Total Recall setups can be stored in this way.
Loading Setups from a Mac or PC ( l0 )
Restoring setups from a Mac or PC is even simpler:
• Enter MIDI mode as before, and turn the D-Pot until the display
changes to ‘ l0 ’ and begins to flash.
• Locate the DAW to just before the SysEx data containing the setups you wish to load.
• Play through the SysEx block of data. The display will show a rotating segment while data is received.
As soon as the X-Rack detects the start of valid data it will delete all the current setups and replace them
with the stored ones from the MIDI track.
4.4.3 Write Protect Mode ( pr )
Write Protect prevents existing stores being over
written or deleted, providing an extra level of
protection for units that have been programmed
with particular settings.
When set to ‘
0n ’ the Save and Delete functions are
disabled. When set to ‘ 0f ’ they are enabled. The
‘ Wr Prot ’ LED lights to show this mode has been
selected.
4.4.4 Remote Mode ( re )
This mode enables remote
control of X-Rack, either from an
AWS 900 for saving and
recalling Total Recall snapshots
or from a MIDI controller for control of the XR622 Master module.
When Remote Mode is ‘
0n ’, selecting a TR setup on the AWS 900 Total Recall page will change the current
X-Rack setup to the one saved in the AWS 900. The X-Rack display will change to read ‘ re ’ (remote).
Pressing the D-Pot will display the TR setup as normal. When Remote Mode is ‘ 0f ’, turning the D-Pot will
change the current X-Rack setup to one of the internal stores but when Remote Mode is set to ‘ 0n ’ the D-
Pot is disabled once the X-Rack has received a setup from an AWS 900. This also prevents saving or
deleting of local stores.
&
SAVE
SAVE
Push to Select
or or
SETUP/
MIDI
SAVE COPY/
DEL
or