Page 20
(Document 82NVBD01A – page 2 of 2)
SDI – User Guide
For eU:
Network I/O SDI is CE compliant and fully conforms with the current protection requirements of the European
community council directives on EMC and LVD. Note that any cables supplied with SSL equipment may be fitted
with ferrite rings at each end. This is to comply with the current regulations and these ferrites should not be removed.
Any modifications to this equipment may adversely affect the CE compliance of this product.
environmental Declaration
The symbol shown here, which is on the product or its packaging, indicates that this product must not be
disposed of with other waste. Instead, it is the user’s responsibility to dispose of their waste using a designated
collection point for recycling of waste electrical and electronic equipment. The separate collection and recycling
of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is
recycled in a manner that protects human health and the environment. For more information about where you
can dispose of your waste equipment for recycling, please contact your local city office, your household waste
disposal service or where you purchased the product.
roHS notice
Solid State Logic has conformed and this product has conformed to European Union’s Directive 2011/65/EU on Restrictions
of Hazardous Substances (RoHS) as well as the following sections of California law which refer to RoHS, namely sections
25214.10, 25214.10.2, and 58012, Health and Safety Code; Section 42475.2, Public Resources Code.
For USA
To the User:
1. Do not modify this unit! This product, when installed as indicated in the instructions contained in the installation
manual, meets FCC requirements.
2. Important: This product satisfies FCC regulations when high quality shielded cables are used to connect with other
equipment. Failure to use high quality shielded cables or to follow the installation instructions may cause magnetic
interference with appliances such as radios and televisions and will void your FCC authorisation to use this product
in the USA.
3. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
electromagnetic Compatibility
EN55103-1:2009, EN55103-2:2009 Environments E1, E2, E3 and E4
Initial in-rush current: 0.6A, 5 sec in-rush current: 0.6A
To maintain electromagnetic compatibility SSL recommends using shielded and foiled twisted pair Ethernet cables of Cat
5e standard or above where applicable.
eMC Performance Criteria
Audio inputs and outputs at -18dBFS. Noise < -74dBFS.
environmental
Temperature:
Operating
:
+5 to 45 deg. C
Non-operating
:
-20 to 50 deg. C
Relative Humidity:
Operating
:
20 to 80% Humidity
Non-operating
:
5 to 90%
Max. wet bulb: 29 deg. C (non-condensing)
Vibration
Operating
:
< 0.2 G (3-100Hz)
Non-operating
:
< 0.4 G (3-100Hz)
Shock
Operating
:
< 2 G (10ms max.)
Non-operating
:
< 10 G (10ms max.)
Altitude
Operating
:
0 to 3000m (above sea level)
Non-operating
:
0 to 12000m
AA
AA
AA
AA
