SDI – User Guide
(Document 82NVBD01A – page 1 of 2)
Page 19
A
PPeNDIx
D – S
AFeTy
N
OTICeS
General Safety
• Please read and keep this document.
• Adhere to all warnings and follow instructions.
• This Electrical equipment should not be used near water.
• Cleaning should only be with dry cloths or products compatible with electrical devices – never when the unit is
powered.
• Keep the unit free of dust and use in a clean environment.
• Do not use near any heat source of in direct sunlight.
• Do not used near naked flames.
• Do not place heavy objects on the unit.
• Do not obstruct the ventilation cutouts in the unit.
• Mount in an adequately supported 19’ rack.
• Only use attachments/accessories recommended by the manufacturer.
• Unplug the device during lightning storms or long periods of unuse.
• The unit can only be serviced by qualified personnel – Seek immediate service if:
–
The unit has been exposed to moisture
–
The unit has been dropped
–
The unit does not operate normally
• Do NOT modify this unit - alterations may affect performance, safety and/or international compliance standards.
• SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised personnel.
Installation Notes
• When installing this apparatus either fix it into a standard 19” rack or place the apparatus on a secure level surface.
• When this apparatus is rack mounted, fit all rack screws. Rack shelves are recommended for this apparatus.
• Allow a 1U gap above and below this apparatus for cooling.
• Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not placed
where they can be stepped on, pulled or tripped over.
Power Safety
• The unit is not supplied with a mains lead allowing you to use IEC distribution of mains cables of your choice. Any
mains cable used is required to fulfill the following standard:
• Use mains cords with the rating: AC - 50/60Hz, 100-240V. 0.4-0.2A each cord.
• The unit should ALWAYS be earthed with the earth on both the IEC sockets (when both are used).
• Please use - complaint 60320 C13 TYPE SOCKET. When connecting to supply outlets ensure that appropriate sized
conductors and plugs are used to suit local electrical requirements.
• Maximum cord length should be 4.5m (15’).
• The cord should bear the approval mark of the country in which it is to be used.
• The appliance coupler is used as the disconnect device, ensure that it is connected to an unobstructed wall outlet.
• The unit is designed for connection to single phase supplies only.
• The clear markings regarding redundant power supplies detailed on the unit must be transferred into the installation
to ensure both power sources are removed before qualified personnel service the unit.
GB
The apparatus shall be connected to mains socket outlets with a protective earthing connection
FIN
Laite on liitettävä suojamaadoituskoskettimilla va rustettuumpistorasiaan
NOr
Apparatet må tikoples jordet stikkontakt
Swe
Apparaten skall anslutas till jordat uttag
ATTeNTION!
This equipment must be Earthed. Refer to manual for installation instructions.
CAUTION!
Disconnect all power sources before removing any panel (s). No user-serviceable parts inside - to
be serviced only by qualified personnel.
wArNING!
Un-Earthed metal parts may be present inside enclosure. Check for hazardous voltages before
touching.
For protection against risk of fire - replace only with same type / rating of fuse. Do not expose to rain or
moisture.
