PRODUCT MANUAL
LEDWizard Tablet and Smartphone LED
Control System w/ Optional Remote
SolidApollo.com
™
Tel. 425.582.7533
Toll Free. 866-592-3873
www.SolidApollo.com
page 10
LEDWizard Wi-Fi Control System
Optional 8 Zone Remote Setup Instructions
Red Indication
Light
Power
Button
Learning Key
Zone 1
AAA Batteries
(Not Included)
Solid Apollo’s 8 Zone color changing RGB-W remote control is fully wireless and can control up to 8 different light zones using just one remote
control. The SenseControl color wheel allows easy color selection, and can be fine tuned to an exact color using the single color buttons. The
controller works great with any LED products which use four channels, such as RGBW (red, green, blue and white). A wall holder is also included for
secure and easy storage.
1. When your receiver and router are set up, please power up
your remote with three (3) AAA batteries (not included) and
press the power button located on the front. Your remote
should indicate it is powered with a solid red indication light
on the front of the Remote.
2. Quickly Tap the “Learning Key” on the white receiver.
3. Now press any button from 1 to 8 depending in which
zone you want to assign to the receiver, in this case we
will press button “1” on the remote.
4. Immediately start sliding your finger in the color wheel of the
remote control, if correctly done, you will see the red LED light
blink on the receivers. It will blink for about 3 seconds. Once it
stops blinking the receiver has been correctly paired.
5. Repeat this with other receivers. You can pair all receivers
to the same zones, in this case 1, or have them in different
zones 1-8.
6. If by any circumstance you wish to reprogram any of the
receivers, you will need to “reset” the receiver. To do this,
simply press the learning button for 5 seconds until the
red LED lights shuts off, and re-do steps 1-5.
