DMX BOSS
W
i-F
i C
on
tr
oller
Page 15
1. When your smartphone or tablet and the DMX
Boss is set up, add power to the remote with three
(3) AAA batteries (not included) and press the
power button located on the front. The remote
should indicate it is powered with a solid red
indication light on the front of the Remote.
2. Plug in and turn on the lights .
3. On the left side of the DMX Boss, tap the learning
switch, then tap the “Zone 1” button on your
remote. Immediately swirl your finger around the
color wheel.
4. You should see your LED lights flash once,
meaning you have synchronized “Zone 1” on your
Remote to that zone.
5. You can now select “Zone 1” on your remote at
any time to control the lights hooked up to that
specific receiver.
6. You can Create up to Six zones by repeating steps
1-6 on this page.
Zone 1
AAA Batteries
(Not Included)
PRODUCT MANUAL
DMX BOSS Wi-Fi Controller
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
Optional Remote Setup Instructions:
When you have configured your system so that it works perfectly with your Tablet or Smartphone Application, you may now configure
your optional Remote for LEDWizard Smartphone & Tablet System, which can be purchased at www.solidapollo.com.
Learning Switch/
Reset Button
Red Indication
Light
Pin1:Data+Pin7:GND
Pin2:Data- Pin8:GND
Learning
Switch
Reset
Switch
12345678