Installation and Operation Manual (Rev B)
13
3.2 Removing the Inverter from the Crate/Pallet and Moving the
Inverter into Place
It is recommended to keep the inverter secured in the crate/pallet and move it as close as
possible to the final location prior to removing the inverter from the crate/pallet. To remove the
crate from pallet, unscrew the #2 Phillips screws from bottom of the crate while holding it on
pallet. Then lift the crate in order to remove the inverter.
NOTE:
Failure to follow these lifting guidelines may cause structural damage to the
inverter and void the warranty.
WARNING:
Do not install the inverter on or over combustible surfaces or materials.
WARNING:
Severe injury or death could occur if the inverter mounting fails and falls on a
person.
NOTE:
The weight of the inverter will exert an added load to the wall or area where
mounted. Be sure to verify proper load capacity of mounting area.
NOTE:
Always use all the (6) mounting plate fasteners.
3.3 Inverter Positioning and Mounting
Correct mounting position for the inverter is vertical. A maximum tilt of 15⁰ in backward direction
is allowed (as shown in figure 3.1).
Figure 3.1 Mounting of Inverter - Allowed