Sole Fitness B54, Owner'S Manual

Page: 22 / 32

Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
22
Factory Setting mode : In standby mode, press
【
ENTER
】
and
【
LEVEL
＋ 】
for 2 seconds to enter
factory setting mode. In this mode, press
【
LEVEL
＋
/LEVEL
－ 】
to select, and press
【
ENTER
】
to the
next setting. When the last option is set by press
【
ENTER
】
, or press
【
STOP
】
during setting, the
setting value will be stored and restarted.
Option item
1. UNIT(KM/ML)
－
Set to English or Metric display readings
2. BRIGHT (0~15)
－
Adjust backlight brightness2
3. SPECIAL (YES/NO)
－
Pull wire motor for special drive action
4. MAX LOAD (16 20 24 32)
－
Set the maximum resistance value
5. UX DATA (ON/OFF)
－
4 sets of user option switches
6. WHEEL (10~99)
－
Wheel setting
The exercise equipment can also play music wirelessly via Bluetooth. Turn on your mobile
phone or tablet’s Bluetooth function. Search for the name "Bt-speaker" in your device’s
Bluetooth menu. Tap to connect. Now your device can transmit music to the exercise
equipment.
General Maintenance
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a larger
wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this
point enough; 90% of calls to the service department for noise issues can be traced to loose
hardware or the rear rails being dirty.
II.
The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the
service department.