18
19
4. Installation
4. Installation
Wall mounting:
Make sure the wall is strong enough to withstand the weight of battery modules.
Step 1: Fix the wall mounting bracket (C1) on the wall
·
Use the wall bracket as a template to mark the position of the 5 holes.
·
Drill holes with a φ10 drill bit, make sure the holes are deep enough(at least
50mm) for installation and then hammer the expansion tubes into the holes.
·
Install the expansion screws(E1) in the wall, and screw the wall bracket(C1) by
using a screwdriver.
Step 2: Remove the upper hanging board which has been installed already.
Step 3: Lift the battery module up and move the battery module close to the
bracket, and then match it on the wall bracket.
Step4: Lock the joint between hanging board and wall bracket with M5
combination screw(F1).
The following figure is the back view of wall mounting.
1m
300 mm
Note: Keep the distance from installation point to the floor less than 1m.
4.5
Cable Connection
4.5.1
Connecting Power Cables
For one battery module:
The color at both end of the power cable© between BMS and battery module is
orange. The power cable will be connected to XPLUG which is at one side of the
BMS (
Ⅳ
) and the battery module (
Ⅰ
’).
1. Plug either end of the 120mm power cable into
the XPLUG port on BMS, and the other end into
the XPLUG port on battery module. When the
metal sheet which is marked in red is totally
inserted and a click sound is heard, that means
the power cable is properly connected.
2. Please make sure that both ends of the power
cable are connected to the correct connector,
which are on the left side of BMS and battery
module that shown in the figure.
3. Once finished, please connect the short-circuit
plug to the YPLUG port on battery module(
Ⅴ
’) to
complete the internal circuit.
Overview of Step 2 and Step3:
