solasfires.com
35
ASSEMBLY & INSTALLATION
Installing the Front Glass Panel and Frame
After burner media and relief doors have been installed,
the next step is to replace the front glass panel and frame.
1. Carefully pick up the glass and glass frame assembly by
grasping the sides of the frame and using your thumbs
and fingers to hold the glass in place within the gasket
and frame.
2. With the glass frame (and glass) held at a slight angle
(leaving room for your fingers between the frame and
the firebox) insert the bottom edge of the frame into
the frame retainer located on the bottom front of the
firebox. Take care to center the frame from left to right.
3. Once the bottom edge is in place, move your fingers
out of the way and press the top of the frame against
the firebox while pushing down to be sure the frame is
fully engaged in the frame retainer.
4. Hold the frame in place with one hand and insert the
four glass frame fasteners along the top edge of the
glass frame. Tighten the fasteners until they are
hand-tight.
5. Tighten each fastener 1/2 turn at a time, working from
one side to the other, until the glass frame has made
contact with the firebox face along the entire top
edge. Do not over-tighten the fasteners as this can put
excessive stress on the glass.
6. Relief door openings must not be covered or blocked
and must be able to slide freely on the brackets.
Relief Door Installation (con’t)
Relief Door front tab engaged on retainers
Relief Door shown in proper operating position
