solasfires.com
27
STARTER PIPE INSTALLATION
6. The exhaust restrictor is installed by placing it through
the exhaust outlet pipe and resting it on the internal
baffle in the firebox. It is held in place with a movable
retainer clip. Simply hold the restrictor down against
the baffle and push the retainer up and tighten screw
to secure the restrictor. Note: Please take care to
ensure that the exhaust restrictor is centered in the
exhaust outlet. Improper alignment could adversely
affect the appearance of the flames. Refer to the
adjacent images for placement of the exhaust
restrictor.
7. Place the Air restrictor between the gasket and the vent
starter pipe. Using a 5/16” nut driver, secure the vent
starter pipe using 4x #10 sheet metal screws provided.
8. Locate the firebox heat shield access panel removed
during step #3 on page 25. To install the inner heat
shield, align the three tabs with the 3 pilot holes in the
firebox heat shield access panel. Using a 5/16” nut driver,
secure the inner heat shield using 3x #10 sheet metal
screws provided. (add picture)
