7
SOLARIS® HITMAN230™
Socket outlets or external power switches used to supply the fixture with power must be
located near the fixture and easily accessible so that the fixtures can easily be disconnect
-
ed from power.
Do not insert or remove power cable to apply or cut power, as this may cause arcing at the
terminals that will damage the connectors.
Do not use an external dimming system to supply power to the fixture, as this may cause
damage to the fixture that is not covered by the product warranty. The fixture can be hard-
wired to a building electrical installation if you want to install it permanently, or a power
plug (not supplied) that is suitable for the local power out- lets can be installed on the
power cable.
If you replace power plug on the power cable, install a grounding type (earthed) plug with
integral cable grip that is rated minimum 250 V, 5 A.
The fixture has an auto-ranging power supply that accepts AC mains power at 100-240 V
at 50/60 Hz. Do not apply AC mains power at any other voltage or frequency to the fixture.
For protection from electric shock, the fixture must be grounded (earthed). The
power distribution circuit must be equipped with a fuse or circuit breaker and
ground-fault (earth-fault) protection.
AC POWER
WARNING! READ SAFETY INFORMATION ON
PAGE 3 BEFORE SERVICING THE FIXTURE.
SECURING WITH A SAFETY CABLE
Secure the fixture with a safety cable (or other secondary
attachment) that is approved for the weight of the fixture
so that the safety cable will hold the fixture if a primary
attachment fails. Loop the safety cable through and around
a secure metal anchoring point.
Summary of Contents for HITMAN 230
Page 1: ...USER MANUAL...
