Collector installation Components:
Note 10-01 collectors will have 2 sets of collector brackets instead of 3
It is important to not over-
tighten these fittings.
Spraying a little silicone on
the threads is helpful.
A couple of turns of Teflon
tape around the ring helps
make sealing easier.
½’ OD Compression
Union and Ell
Compression Ell
Nut with Ring Inside
Tube must extend beyond ring
about ¼” and bottom out inside the
compression body before tightening
nut
Nut, Ring, Union Body
PV Parts Bag contains PV
switch Brackets and
hardware. See 9.0,
Control Component
Detail.
Roof Kit contains:
Mounting Ells and washers,
3.5 or 4” Lags,
Center U Brackets for 2 or
more collectors,
Color coded Tec Screws for
securing Ell brackets and U
brackets to collector,
Low profile Roof Boots.
Plumbing Kit:
50’ of ½” OD Copper,
Pressure Relief,
Coin (air) vent,
Soldered adaptor,
Compression fittings,
1 Compression union
body per extra
collector,
2 compression unions
to connect tubing to
tank.
Important Instructions Regarding Installing Compression Unions
Summary of Contents for SkyLine 200152C80EX
Page 31: ......
