A NOTE ON MAKING TUBE
CONNECTIONS:
The tube connections top and bottom shown in top
view as 3 & 5, are made at the top and bottom of ONE
end of the collector. The connections can be at either
end of the collector simply by placing the collector
end left or right. When two or more collectors are
used they also connect at the same end (4).
Make sure you do not have a rafter
directly under the collector feed as the
feed hole is 1 and ½ inches below and in
from the end of the collector.
MOUNTING RAIL AND MOUNTING
BRACKET INSTALLATION STARTING
WITH SINGLE COLLECTOR:
A single 20-01 collector is attached to the roof by
three "mounting rails and 6 mounting Ell brackets"
(2).
Position the Ell bracket
between the
trim and frame
so it is
CENTERED
over the Lag hole.
Install the collector
onto the rails with the mounting bracket tab
UNDER the trim and BETWEEN the frame.
The small bend at the bottom of the trim makes
inserting the mounting bracket easy. Be sure to
press the collector all the way down on the
mounting rail and secure with two 1/4” color
coded self tap screws evenly just above the
small bend in the trim.
Be sure to catch the tab
with both screws!
Above: Complete Collector mounting kit
for 2 collectors. 3 Ell brackets bottom,
three U bracket sets per additional
collector and 3 Ell brackets top.
Note: 10-01 collector has 2 sets of each.
Above: Top Ell Bracket in place and
ready for top collector to be installed.
Summary of Contents for SkyLine 200152C80EX
Page 31: ......
