Operating Instructions and Installation Guide
Wall Mounted Split System
Page 35
2.4 Evacuate Tube Thermal Collector Installation
Insert the white plastic collars provided into the holes
in the evacuated tube bracket.
Lightly lubricate the black rubber seals provided with a
detergent solution and slide them onto the evacuated tubes
with the open end of the seal facing up towards the open
end of the tube.
Lubricate the white plastic tee joint (water drain) with the
detergent solution then push softly through the hole located
on the right hand side of the tank. Gently twist as you push
to ensure that the silicon sealing ring is not dislodged.
If in use or installation one of the glass evacuated tubes is
broken, fill it’s corresponding hole in the bottom tank with a
similar sized and shaped object until a replacement tube can
be sourced from the distributor of the product. This is only
recommended as a temporary fix until a replacement can be
sourced as it will negatively affect the efficiency of the
Thermal Collector.
-
-
_______________________
In cold areas, an anti freeze must be added to the water at a
rate of 50/50.
Slide the black rubber seal up to seal off the silicon sealing
section from the elements.
Lubricate the air vent (assembly with red cap) lightly with the
detergent solution then push softly through the hole located
at the top left hand side of the tank, gently twist as you push
to ensure that the silicon sealing ring inside is not dislodged.
Push each tube softly into the silicon holes in the tank until
they are secure, then push across.
4.
5.
6.
