SOGEDIS HP T2, Service Manual

Page: 9 / 69

HP T2 PANEL
SERVICE MANUAL
5.2. Service Autotest Steps
STEPS Control
Minimum Step
Duration*
Error
code
Led Indication Possible Errors
The Routine to
Enter Servis
Autotest
Set program knob at position 3. Push SW5
button.
Keeping SW5 button pushed, turn program
knob to position 1. After 3 sec, SAU is shown
in display.
Then press Start/Pause button. Machine
enters to service autotest.
For T2: When machine enters service
autotest, SAU becomes fix on for 2 sec and all
warning leds make fast blink for 2 sec and
then becomes fix off
For T2: Machine shows the last error saved
by machine. If there is no error, "- - -"
visualise on the display
When knob positioned to program 2, control
steps starts.
5 sec -
Step 2
(Knob Position
2) Dryer check Aquaswitch, if aquaswitch ON go
to next step (pump activation), if aquaswitch
OFF give water tank full error
10sec
E03 -
*Aquaswitch connector is
taken out
*Aquaswitch connector is
short circuit
*Styrofoam is borken or not