Cha pter 6 - Techni ca l da ta
© Softing Industrial Automation GmbH
33
6
Technical data
6.1
Specifications
Power supply
18 VDC...32 VDC; SELV/PELV supply mandatory
Typical input current is 200 mA; maximum is 1 A (considering the
rush-in current at switch-on).
FF-H1
Four FF-H1 channels, compliant with type 114 of the FF physical
layer profile. The Fieldbus voltage range is from 9 VDC...32 VDC.
Preferred value is 24 VDC.
Ethernet
IEEE 802.3 100BASE-TX/10BASE-T
Only ETH 1 is supported. Do not use ETH 2 (reserved for further use).
Minimum ambient
operating
temperature
-40 °C
Storage temperature -40 °C...+85 °C
Relative humidity
10 %...95 % (non-condensing)
Altitude
Must not exceed 2,000 m
Location
Indoor use only; no direct sunlight
Coating
Conformal Coating based on ANSI/ISA-S71.04 G3
Safety standard
IEC/EN/UL 61010-1 Safety requirements for electrical equipment for
measurement, control and laboratory use - Part 1: General
requirements: IEC/EN/UL 61010-2-201 Safety requirements for
electrical equipment for measurement, control and laboratory use -
Part 2-201: Particular requirements for control equipment (both
with CB scheme).
Ingress protection
IP20
