dataFEED edgeGate - Quick Startup Guide
12
Copyright 2017 Softing Industrial Automation GmbH
Using a single common network
If there is only one (logical) network, it is recommended to connect the dataFEED edgeGate
only via the Ethernet interface of the IT side with the network. In this case, the Ethernet
interface of the machine side should be disabled by setting the IP address to 0.0.0.0 and
the subnet mask to 0.0.0.0.
2.4
Powering up the device
Turn on the power supply. The boot process takes a few seconds. For indication of proper
operation of a dataFEED edgeGate refer to
.
2.5
Inserting an SD card
On the bottom of the device you find a slot for a micro SD card. You can save your gateway
configuration data to a storage card and reload it from here in case your device settings
have been accidentally corrupted.
Note
The storage capacity of the micro SD card may not exceed 32GB.
1. Remove the card slot cover on the bottom of the device.
2. Insert the SD card carefully into the slot until the card clicks into place.
