Sodi RS3 KZ DD2, User And Maintenance Manual

Page: 10 / 50

10/2022
10
EN
USER AND MAINTENANCE MANUAL
● Tighten the assembly.
● Put the fastener clip (3).
Étape 3
2
1
Legend
1 Ball joint
2 Stub axle arm
● Cut the tie-wrap maintaining the stub axles.
● Place the ball joints (1) above the stub axle arm (2).
● Insert the screw into the stub axle arm.
● Place the washer between the ball joint (1) and the stub
axle arm (2).
● Tighten the nut.
● Tighten the assembly.
Étape 4
1
4
3
2
Legend
1 Support
2 Screw
3 Top of the wheel
4 Steering column
● Tighten the steering wheel (straight side up (3)) with the 3
screws (2) on the steering wheel support (1).
● Tighten the steering wheel support (1) on the steering
column (4).
● Once the steering system is assembled,
please check that the steering wheel is free to
make a quarter of a turn right and left.
► A bad assembly or a bad adjustment of
the steering system can lead to accidents.
Systematically check the tightening of the
system and its adjustment.
3.6 - Assembly of the seat
●
See
Standard adjustments, p. <EX>
for the
assembly dimensions corresponding to the
standard setting recommended for your frame.
Legend
1 Fixing points
2 Seat supports
● Get the seat support ends (2) closer, or wider, depending
on the seat size.
● Use the shims of the seat fixing kit to get a good fit.
Ground clearance
A
1
2
Legend
1 Seat
2 Frame tubes
● Adjust the bottom of the seat (1) with the lower face of
the frame tubes (2).