1. Introduction
This product complies with the requirements of the following European Community Directives:
2004/108/EC (Electromagnetic Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking). Overvoltage category CAT III 1000V / CAT IV 600V ; pollution degree 2.
2. Safety Precautions
To ensure safe operation of the equipment and eliminate the danger of serious injury due to short-
circuits (arcing), the following safety precautions must be observed. Damages resulting from failure to
observe these safety precautions are exempt from any legal claims whatever.
Do not exceed the maximum permissible input ratings (danger of serious injury and/or of the
equipment).
Comply with the safety rules.
Check test leads and probes for faulty insulations or bare wires before connection to the
equipment.
Check the proper functioning of the unit before the housework at a known circuit
Pay special attention when connecting the included flexible current probes on a hedge against
touching the live wires.
Replace a defective fuse only with a fuse of the original rating. Never short-circuit fuse or fuse
housing.
Never touch the tips of test leads or probes.
Comply with the warning labels and other info on the equipment.
Conduct measuring works only in dry clothing and in rubber shoes, i. e. on isolating mats.
Always start with the highest measuring range when measuring unknown values.
Disconnect test leads or probe from the measuring circuit before switching modes or functions.
Do not subject the equipment to direct sunlight or extreme temperatures.
Do not subject the equipment to extreme humidity or dampness.
Do not subject the equipment to shocks or strong vibrations.
Keep hot soldering irons or guns away from the equipment.
Allow the equipment to stabilize at room temperature before taking up measurement (import for
exact measurements).
Only for indoor-use.
Measuring instruments don´t belong to children hands
2.1. Safety Symbols
Attention ! Risk of electric shock! Do not open the case during a measuring process!
Attention !
Do not apply over-voltage to the input jacks! Remove the test set cords before opening the battery
compartment! Cleaning - Use a dry cloth to clean the housing! Observe all safety notes in the operating
instructions!
-40-
