9
WINDOWS PC
SPP MODE
To install the software and configure a COM port:
1.
Insert the SocketScan 10 installation CD into your computer and follow the instructions
to install the software for Windows Desktop.
2.
When prompted to configure a Bluetooth COM port, click
Yes
.
3.
In SocketScan 10 Settings, select an incoming Bluetooth serial COM port. Click
OK
.
Click
Ports
to create a new incoming COM port or identify an incoming COM port.
4.
At the end of the installation wizard, click
Finish
. If prompted, restart the PC.
5.
Windows Vista only: Right-click on the SocketScan 10 desktop icon. In the pop-up
menu, click
Properties | Advanced
. Select
Run as administrator
and click
OK
.
To pair the CHS with the PDA or PC:
(required only the first time you connect)
1.
Power on the CHS. Scan this barcode to change the CHS to SPP mode. It will beep 3 times.
2.
Use your Bluetooth software to start a device search / add a device. In the list of found
devices, select
Socket CHS
. If prompted for a passkey, enter
0000
(four zeroes).
If prompted, choose the service
Socket Serial Port
. Select an available COM for the CHS.
3.
Make sure SocketScan 10 is running. Click on the SocketScan 10 desktop icon
.
4.
Click on the SocketScan 10 icon
in the task tray. In the pop-up menu, click
Socket
EZ Pair
. Click
1D Scanner
. Select your CHS and click
Pair
.
5.
The PC will connect to the CHS, indicated by a beep. The CHS will then disconnect from
the computer, indicated by two beeps. Click
OK
.
6.
After the CHS connects and is ready to scan barcodes, it will beep once. The task tray
icon will also change (see below).
7.
Close Socket EZ Pair. The Registration screen will appear. If desired, register your CHS.
Task Tray Icon
CHS not connected.
CHS connected.
Now you are ready to scan barcodes, see instructions on page 4.
To connect to a new device, you must first unpair the CHS. See page 4.
Print page to scan.
Do not scan onscreen.