for each step. You can connect 2A to another synthesizer parameter to have more
control (for instance, filter Q).
•
If you touch the upper-left round button once, it turns amber and changes the sliders to
be controlling another “page” of slider values. The second page of slider values is for the
outputs on 2B and 2C. Try changing those. Then, try touching the upper-left round
button again, and it will turn red to show the third page of slider values. These are
octave (top slider) and step length (bottom slider). Try changing those for the different
steps.
•
How about some glide? If you hold down the unlit Upper Hexagon between E and F,
and touch the top slider while holding it down, you will set the glide time for the pitch
of that step (which applies to the glide TO that step). Doing the same and touching the
bottom slider will change the glide time for the slider CV values of that step. Glide
values of about 20% are close to the glide time of a TB-303, so see if you can get a good
TB-303 emulation going.
•
Want to detune some notes? While holding down a pitch on the Upper Hexagons, drag
the bottom slider. This will detune the note. You can also quickly adjust the octave of a
pitch by dragging the top slider while holding the pitch hexagon down.
•
Try going back into Play Mode by touching the upper-right round button again. Now
you can add or remove more steps from the sequence by touching them.
•
Figure 5: Sequencer Mode Right Option Menu
