Lit. No. 74256, Rev. 02
17
February 15, 2020
Setup Codes
Code
De
fi
nition
Procedure
Cb
Calibrate the Empty Hopper setting.
With the control in ON mode, press and hold the left control knob until
the
Cb
code displays. Calibration cycle is automatic.*
Cc
Clear calibration data for Empty Hopper
setting; clear
EH
code.
Press the right control knob to clear all calibration data during the
calibration cycle.
LS
Set LED brightness level.
With the control in Ready mode, press and hold the left control
knob to get
LS
code. Release pressure and turn left control knob to
desired brightness setting. Wait for con
fi
rming
SL
code to display.*
SL
Con
fi
rms that LED brightness level has
been reset.
*
For full instructions, see the Setup Procedures section.
Information Codes
Code
De
fi
nition
Response
Ar
Auto-reverse sequence is active.
The spreader will automatically detect and attempt to clear a jam. If
auto-reverse is unsuccessful, turn the spreader OFF and extract the
material that is causing the problem. Follow all warning directions
when clearing jams.
dU
Not applicable to tailgate spreaders.
Possibly indicates a harness or
module issue.
Contact authorized dealer.
EH
Empty hopper (beep will sound).
Check hopper for material.
Recalibrate Empty Hopper setting as described above for
Cb
code.
Lb
Low battery. Hopper module is sensing
<10V. (
Lb
becomes an error code
when module senses <6V.)
Refer to the
Lb
row under "Error Codes" (next page).
CAB CONTROL CODES
Error Codes – Spreader Operation Stopped
Code De
fi
nition
Possible Cause
Suggested Solution
bb
Bad button.
Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Possible harness issue.
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
Check connections and integrity of vehicle
harness.
bH
Bad hopper.
Possible module or control
mismatch.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
CE
No communication with
spreader module.
Loose connection.
Module lost power.
Con
fi
rm that spreader and control harnesses are
connected to the vehicle harness. Check fuses,
power to spreader module, all connections, and
power studs. Check that port B is plugged into
the module.
CF
Control malfunction.
Control is overheating.
May be a combination of faults.
Inspect connections at spreader module, hopper
drive motor, and spinner drive motor.
OPERATING THE SPREADER – CAB CONTROL
Summary of Contents for V-Pro 32200
Page 2: ......
