13
© Trynex International 2012 (REV A) F50734
Wiring Instructions
Model # SP-9500X
1. Mount rear plug bracket on back of vehicle using supplied bolts. Locate toward center of bumper as it will reduce the amount of tire-
thrown debris that gets onto the plug.
2. Mount harness plug to rear plug bracket that was just installed. Apply a small amount of dielectric grease to plug.
3.
Route wires from back to front using ty-wraps or clamps (not supplied). Do not secure to brake lines, fuel lines, or near exhaust, engine or
moving parts. Use the heavy-duty ty-wraps along frame and the lighter duty ty-wraps everywhere else.
4.
Drill a 7/8” hole in the firewall near steering column. Be sure to check for wires in the way (both sides of firewall) before drilling the hole.
Run a communication wire into cab. Zip-tie wire under dash so it does not get in the way of brake or accelerator pedal. Leave enough of
the communication wire outside of the dash so operator can hold control pendant in hand.
5. Route power wires over to battery. Install circuit breaker and connect to battery.
Remember: Red (+) to positive. Black (–) to negative.
