© Trynex International 2012 (REV A) F50734
10
Operating the Spreader
(continued)
Model # SP-9500X
ADJUSTABLE SPINNER INSTRUCTIONS
Your spreader is equipped with an adjustable spinner to assist you in more precise material application. The Spinner plate gives the operator
control of whether the material spreads to the right, left or is centered. All of the fins should be in the same position; this will keep the spread
pattern consistent and have even ground coverage. Before operating the spreader, spread some material in a clear area where you can easily
observe the spread pattern and how it changes. Adjust according to the instructions below to get the pattern you desire.
When looking down at the spinner, moving the fins clockwise will
adjust the spread pattern toward the left side of the spreader.
When looking down at the spinner, moving the fins counter-clockwise
will adjust the spread pattern toward the right side of the spreader.
When the fins are in their center adjustment position, the spread pat
-
tern will be mostly centered. However, collisions and other damage to
the equipment may change this. Check the fin position and resulting
spread pattern often enough to prevent the equipment performance
from being adversely affected.
