Lit. No. 70691, Rev. 01
15
July 15, 2018
OPERATING THE SPREADER – CONTROL
POWERING THE CONTROL
Power is not applied to the control until the vehicle
ignition is turned to ACC or ON.
STARTING AND STOPPING SPREADER
To start the spreader
, press the POWER switch.
Adjust SPINNER and AUGER speeds with the two
knobs. Speed will be displayed on the screens. Adjust
to get the desired spread width and application rate or
"Spread Pattern."
Use the vibrator to loosen bridged material and
improved
fl
ow to the auger with the VIBRATE switch.
The vibrator does not have to be on continuously.
Turn the spreader OFF with the POWER switch when
you are done spreading, or need to pause. The spread
pattern will not change as long as the knobs are left in
the same position.
NOTE: The vehicle ignition must be ON to start
the spreader.
NOTE: If vehicle ignition is turned OFF while
spreader is running, the motors will stop.
Spinner Speed
Auger Speed
Vibrator
ON
Power
OFF
WARNING
Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.
WARNING
Never operate equipment when under the
in
fl
uence of alcohol, drugs, or medications that
might alter your judgment and/or reaction time.
WARNING
Never exceed 45 mph (72 km/h) when loaded
spreader is attached to vehicle. Braking
distances may be increased and handling
characteristics may be impaired at speeds
above 45 mph (72 km/h).
WARNING
Never allow children to operate or climb on
equipment.
Summary of Contents for Precision Pro SP-1675
Page 2: ......
Page 4: ...Lit No 70691 Rev 01 4 July 15 2018...
