Snorkel SL26RTE, Manual

Page: 147 / 209

Page 3 - 17 SL26/30SL
CALIBRATE LEVEL
•
This machine is equipped with level sensors for the chassis, the front axle and the platform as
follows:
1. Chassis level sensor: This is incorporated in the ECU (GP400 control module) in the lower
control box.
2. Front axle level sensor: This is a pair of CANtilt level sensors mounted on the front axle.
There are two available for self checking incase one fails. Elevation above elevated height is
not allowed if the front axle is out of level with the chassis by more than 1 degree.
3. Platform level sensor: This is a pair of CANtilt level sensors mounted on the rear of the 1st
post weldment. There are two available for self checking incase one fails.
! W A R N I N G !
If the GP400 control module or any of the CANtilt level sensors are replaced
and/or moved, level on the full system must be recalibrated using the proce-
dure provided. Failure to do so could result in serious injury or death.
SERVICE AND REPAIR
Figure 3-11 : Platform
CANtilts, Lower control
box and Front axle CANtilts
location
Platform CANtilts
Front axle CANtilts
Lower control box