Snorkel ML10I, Operator'S Manual

Page: 17 / 28

ML5I • ML10I • ML15I • ML20I • ML25I – 7030242 13
Chapter 5 – Operation
Danger
The material lift is not electrically insulated. Death
or serious injury will result from contact with, or
inadequate clearance from, an energized conductor.
Do not go closer than the minimum safe approach
distance as defined by ANSI.
Warning
Pinch points may exist between moving components.
Death or serious injury could result from becoming
trapped between components, buildings, structures,
or other obstacles. Make sure there is sufficient clear -
ance around the machine before moving the material
lift. Allow sufficient room and time to stop movement
to avoid contact with structures or other hazards.
The material lift can tip over if it becomes unstable.
Death or serious injury could result from a tip-over
accident. Operate the material lift on a firm, flat, level
surfaces. Do not position the material lift for elevated
use near any drop-off, hole, slope, soft or uneven
ground, or other tip-over hazard.
The maximum load capacity is the total weight of th
equipment that may be lifted with the material lift forks.
The maximum load capacity is stated on the lift serial
plate and is listed in the machine lift specifications in this
manual.
Warning
The material lift can tip over if it becomes unstable.
Death or serious injury could result from a tip-over
accident. Do not exceed the load capacity values
indicated on the machine serial plate and in this
Operator’s Manual.
Capacity values indicate the rated lifting capacity and do
not indicate material lift stability.
The operator bears ultimate responsibility for ensuring
that the material lift is properly set up for the particular
conditions encountered.
This section provides instructions for the safe and proper
operation of the material lift. It is the responsibility of the
operator to follow these instructions. Failure to follow
these instructions, as well as all safety rules in this man-
ual and attached to the material lift may result in serious
injury or death.
During operation:
y
Follow all of the safety rules provided in previous
sections of this manual.
y
Follow all instructions provided in this section.
Set Up
To set up the machine, select an area that is firm, level
and clear of debris and overhead obstructions.
Follow these steps to set up the machine.
Material lifts equipped with stabilizers
1. Push down on the stabilizer lock plates to release
the stabilizers.
2. Lower the stabilizers until the casters are in contact
with the ground.
3. Verify that the lock plates are engaged and the sta-
bilizers are locked in the down position.
4. Remove the leg retainer pin.
5. Lower the leg to the down position.
6. Insert the leg retainer pin through the leg and the
base.
7. Repeat the above steps to lower and secure the other
leg.
8. Place the desired load lifting attachment (standard
forks, adjustable forks, boom) inside the carriage.
9. Insert the fork retainer pin through the load lifting
attachment and the carriage.