Charging the internal battery
My Speed XL
Although My Speed XL can be charged using the cigarette lighter in your vehicle,
an alternative method of charging is via a USB socket of a PC, or USB Mains charger
(output of 5v 1000mA - not supplied).
The battery light on the device will illuminate and will take approximately 3 hours
to charge. When the internal battery is fully charged, the red LED will turn blue.
Snooper recommends that the unit is swit
ched off
, to minimize the charge time.
Note: The new battery’s full performance is only achieved after two or three
complete charges and discharges.
Powering Snooper using the built-in battery
Once the device is fully charged, it is ready for use. Press and hold the power switch on the top of the unit for 2 seconds to switch it
on.
Note: the battery is designed to be a back up and Snooper recommends that the the navigation device is powered from the
vehicle charger.
NOTE: The battery symbol will only appear if the device is switched OFF during charging. The screen will go blank after a few
minutes, the status LED will illuminate during charging.
Status LED
On Battery – No LED
On Charge – RED
Fully Charged – Blue
ON/OFF
switch
Plug the
charger cable into
the USB socket on the
side of the My Speed XL
EN Page 13 of 43
MY Speed combined V3.0 02/21
Summary of Contents for My-Speed XL
Page 1: ...User manual...
