Kudos Pro UHD1000
System Operation
Issue 1 Rev 2
Page 30
© 2016 SAM
•
Silence
•
Forced silence
6.4.4.7
Out Pair Status
Status information is available for each output pair from the output pair list (Output pair 1 to
Output pair 8).
•
PCM
•
Muted
•
Test tone
•
Non-PCM
•
Forced silence
6.4.5 Memory
The
Memory
button allows the unit to be reset to its original configuration. Available functions
are:
6.4.6 Home
Causes the Home screen to be displayed.
6.4.7 Convert
Convert
provides a set of solutions to enable optimized conversion of film-originated content.
Film-originated content may be transported by standards supporting the original film frame
rate, such as 1080 23.98p. Film-originated content may also be packed into interlaced
standards using a rule-based method to map source frames to interlaced fields. In this case,
the interlaced standard's content is described as having a
film cadence
.
In order to perform high quality conversion of film-originated content, the cadence must be
identified and used to adapt the interpolation process.
Film mode
(See section 6.4.7.2) also
permits the synthesis of film cadence in the output.
Note:
•
The
Audio Shuffle
menu allows any configuration of audio channels to be routed
to the output. Illegal combinations will result in the output being forced to silence.
•
If both audio channels of an audio pair have been derived from non-PCM audio
channels, there are two possible states,
Non-PCM
or
Forced silence
. To be
recognized as valid non-PCM, both channels must satisfy 3 conditions:
•
have come from the same input pair;
•
have the left and right channels the correct way round;
•
not have the phase inverted.
Failure of any of these conditions will cause the pair to be muted and the status to
be reported as
Forced silence
.
Menu Option
Operation
Reset to Defaults
All controls are reset to their default values,
except
for network configuration and IP addresses.
Factory Reset
All controls are reset to their default values,
including
network configuration and IP addresses.
