IQSDA41/42
Operation Using the RollCall Control Panel
Issue 1 Rev 1
Page 25
© 2017 SAM
Where N is the input number
5.8.4 Address
This item enables the address of the selected destination unit to be set.
The address may be changed by typing the new destination in the text area and then
selecting the
S
button to save the selection. Clicking the
P
button returns to the default preset
destination.
The RollTrack address consists of four sets of numbers, for example,
0000:10:01*99
.
•
The first set (
0000
) is the network segment code number.
•
The second set (
10
) is the number identifying the (enclosure/mainframe) unit.
•
The third set (
01
) is the slot number in the unit.
•
The fourth set (
99
) is a user-defined unique identification number for the destination
unit in a multi-unit system. This ensures that only the correct unit will respond to the
command. If left at 00 an incorrectly fitted unit may respond unexpectedly.
5.8.5 Command
This item enables a command to be sent to the selected destination unit.
The command may be changed by typing a code in the text area and then selecting the
S
button to save the selection. Clicking the
P
button returns to the default preset command.
The RollTrack command consists of two sets of numbers, for example:
84:156
.
•
The first number (
84
) is the actual RollTrack command.
The second number (
156
) is the value sent with the RollTrack command.
5.8.6 RollTrack Sending
A message is displayed here when the unit is actively sending a RollTrack command.
Possible RollTrack Sending messages are:
5.8.7 RollTrack Status
A message is displayed here to indicate the status of the currently selected RollTrack index.
Possible RollTrack Status messages are:
TX N Bias High
LASER Bias currently above limits.
TX N Bias Low
LASER Bias currently below limits.
RX N Power OK
Receive power is within limits.
RX N Power High
Receive power is above limits.
RX N Power Low
Receive power is below limits.
RollTrack Source
Description
Message
Description
String
A string value is always being sent.
Number
A number value is always being sent.
No
The message is not being sent.
Yes
The message is being sent.
Internal Type Error
Inconsistent behavior. Please contact your local SAM agent.
