IQSDA41/42
Operation Using the RollCall Control Panel
Issue 1 Rev 1
Page 22
© 2017 SAM
5.6 Logging - Input
The
Logging - Input
page displays current input logging information.
The following options are available. Enable check boxes to activate log fields as required.
Where N is the input number
Log Field
Description
INPUT_N_STATE=
Reports current state of the input signal. Valid values are:
•
OK
: input signal good.
•
FAIL
: input signal not detected.
INPUT_N_SDIRATE=
Reports current bit rate for the input.
INPUT_N_TYPE=
Reports current input type. Valid values are:
•
HD
•
SD
•
3G
•
6G
•
12G
•
SDI
INPUT_N_IDENT=
Reports system-defined identifier for the input, based on
the rear ID.
INPUT_N_NAME=
Reports name of the input, as defined on the Setup page;
see section 5.4.
