Not for
Reproduction
14
800X Series Zero-Turn Rider - 61” & 72” Mower Deck
ferrismowers.com | snapperpro.com
Fine Adjustment Procedure
1. Loosen the jam nut (
A, Figure 28
) and turn the fine
adjustment bolt (
B
) to adjust the deck height until the
front measurement equals 4” (10,2 cm) and the back
measurement equals 4” (10,2 cm)
• Turn the bolt CLOCKWISE to raise the deck.
• Turn the bolt COUNTER-CLOCKWISE to lower the
deck.
2. Position the outside mower blades so that they face
front-to-back.
3. Re-measure from the front tip of the blade from the
cutting edge to the ground. Measure from the rear tip of
the blade from the cutting edge to the ground. Repeat
the process for the other side of the machine.
3. Once the front measurement equals 4” (10,2 cm) and the
back measurement equals 4” (10,2 cm), re-tighten the
jam nut.
B
A
Figure 28. Fine Adjustment of the Deck Cutting Height
A. Jam Nut
B. Fine Adjustment Bolt
Figure 29. Deck Lift Spring Location
A. Deck Lift Spring
Deck Lift Spring
The deck lift springs (
A, Figure 29
) are factory set to
provide optimal lifting performance.
Although it is fastened with an adjustable anchor, this is
NOT an adjustment point.
Do NOT attempt to adjust the length of the deck lift spring
or lifting performance will be compromised.
A
