Snapper YT2452F, Manual

Page: 19 / 116

Operation
19
en
Storage
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety Rules
section, then perform the following steps:
• Disengage the PTO, set the parking brake, & remove the
key.
• Perform engine maintenance and storage measures
listed in the engine owner’s manual. This includes
draining the fuel system, or adding stabilizer to the fuel
(do not store a fueled unit in an enclosed structure - see
warning).
• Battery life will be increased if it is removed, put in a cool,
dry place and fully charged about once a month. If the
battery is left in the unit, disconnect the negative cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended checks and procedures found
in the engine owner’s manual.
• Allow the engine to warm up for several minutes before
use.
Attaching a Trailer
The maximum horizontal drawbar force allowed is
444 Newton. The maximum vertical drawbar force is
222 Newton. This equates to a 396 lbs (180 kg) trailer on a
10 degree hill. Secure the trailer with an appropriately sized
clevis pin (A, Figure 6) and clip (B).
WARNING
Never store the unit with fuel in an enclosed,
poorly ventilated structure. Fuel vapors can travel
to an ignition source such as a furnace, water
heater, etc. and cause an explosion.
Fuel vapor is also toxic to humans and animals.
Adjusting Mower Cutting Height
The cutting height is adjustable between 1.0” and 4.0” (2,5
and 10,0 cm).
The cutting height adjustment switch (A, Figure 5) controls
the mower cutting height. This same switch also controls
the spout rotator motor when a snowthrower is installed.
The arrows on the switch correspond to the direction of
adjustment (UP arrow raises cutting height, RIGHT arrow
rotates the spout right, etc). When the adjustment indicator
has reached the end of its travel, release the switch; holding
the switch down will damage the motor.