Snap-On Thermal Laser, User Manual

Page: 15 / 34

7
Operation Changing Viewing Modes
NOTE:
i
When the Thermal Laser is turned on, the viewing mode that was active when the unit was turned
off is resumed.
Pressing the UP▲ or DOWN▼ control buttons allows you to change the viewing mode.
Press the UP▲ control button repeatedly to increase thermal opacity, full UP = 100% ( Figure 4-3 ).
Press the DOWN▼ control button repeatedly to decrease thermal opacity ( Figure 4-3 ).
Figure 4-3
At the 20% level ( Figure 4-3 ), pressing DOWN ▼ once displays the Diffused Beam view. This view
displays at 100% opacity at center and gradually decreases radially to 0% ( Figure 4-4 ).
Figure 4-4
From the Diffused Beam view, pressing DOWN ▼ once displays laser spot temperature mode, see
Using Laser Spot Temperature Mode on page 8.
20%
40%
60%
80%
100%