Snap-On Thermal Laser, User Manual

Page: 31 / 34

23
Maintenance Battery Pack
Risk of electric shock.
•
There are no serviceable parts inside the unit. Do not disassemble the unit or try to
remove the cover. Removal of the cover could result in an electrical shock, and will
void the product warranty.
Electric shock can cause personal injury.
NOTE: NOTE:
i
When the battery reaches a low charge level (approximately one bar indication on icon), the LED
spotlight is disabled.
1. Turn the LED spotlight off.
2. Open the protective cover on top of the Thermal Laser (
Figure 6-1 ).
3. Connect the USB cable to the micro USB jack.
Figure 6-1
IMPORTANT:
It is highly recommended to use the supplied USB power supply adapter to charge the battery.
Using a non-approved power supply adapter (max. 500mA charge rate output) may result in
insufficient charging.
4. Connect the USB cable to the USB power supply adapter.
5. Connect the USB power supply adapter, to a live AC power source.
NOTE: NOTE:
i
The battery pack will also charge when the USB cable is connected to a PC (using the power
supplied from the PCs USB connection).
The battery charge indicator LED is located on the front of the Thermal Laser below the
DOWN▼ control button ( Figure 6-2 ).
–
A red LED indicates the battery is being charged.
–
A green LED indicates the battery is fully charged.
:$51 ,1*