9
Commands are transferred by pressing the various operating buttons on the remote control.
The remote control has a pre-set functioning time. Once the time has run out it is necessary to reset the ON-OFF
receiver.
For correct use of the system carefully follow these instructions
:
-
Park the vehicle in a safe place, turn off engine, pull on the handbrake.
-
Check that there are no obstacles and lower the 4 feet to the ground.
-
Locate the longitudinal level and begin levelling the 2 feet most distant from each other.
-
Locate the side level by pressing the 2 lateral cylinder buttons and you will be level stabilized in a few seconds.
-
Once you have finished the manoeuvre, turn the control panel to OFF.
-
Only use individual control buttons for small corrections, if necessary.
If for some reason the tyres are off the ground, use the 2 buttons simultaneously to lower them and only when all the
tyres are resting on the ground should you use the button for automatic levelling of all the cylinders.
Warning
Improper use of these buttons could cause damage to the structure and to persons.
SMV DECLINE ALL RESPONSIBILITY FOR ANY DAMAGE CAUSED BY IMPROPER USE OF THE SYSTEM.
LIFT FRONT
LEFT FOOT
LOWER FRONT
LEFT FOOT
EMERGENCY
BUTTON
AUTO-LEVELLING
(IF SUPPLIED)
SIMULTANEOUS
LIFTING OF 4 FEET
SIMULTANEOUS
LOWERING OF 4 FEET
PRESS SIMULTANEOUSLY
TO LIFT 2 BACK FEET
Summary of Contents for MULTI-LIFT SYSTEM
