Assembly
Step 23:
Attaching the Burner Tubes to
the Grill
Locate:
(3) Burner Tubes with Igniter elec-
trodes attached and (3) ST 4.0x10 Screws.
Procedure
: Attached to each Burner Tube
is an Ignition Electrode with a pin at the end
of the Electrode. You need to attach each
of the (3) ignition wires that you had
pushed through the openings onto the pin
end of the Electrode per Fig. 23A.
Refer to Fig. 23B and Fig 23C. Tilt the
burner tube slightly and insert through the
opening in the front wall of the cabinet. You
MUST
make certain that the tip of the valve
is completely
INSIDE
the end opening of
the Burner Tube.
After each Burner Tube is set in place at
the front of the Cabinet, you must fasten
the Burner Tube to the Burner Support
Brackets at the back of the cabinet with an
ST 4.0x10 screw per Fig. 23D.
Step 22
:
Attaching the HVR Cover
Locate
: HVR Cover and (2) M6x15 bolts
Procedure
: Refer to Fig. 22 and set the
HVR Cover in the front corner of the Gas
Grill Cabinet, so that it covers the actual
HVR where it enters and exits the Cabinet.
Fasten in place with (2) M6x15 bolts.
Be sure top of cover is positioned under the
Rivnut as shown.
Step 22
Fig.22
Step 23
Fig. 23B
Fig. 23A
Fig. 23C
Fig. 23D
Rivnut
22
