4.3 How to clean a board accurately
Clean a PCB as follows:
After blown off the fluid residue with a air gun the board will be brushed with alcohol (for example) and
blown off with the air gun again. Do this two or three times to make sure all the residues are gone.
5 Replacement/Mounting/Demounting
Disconnect the ENTERPRISE TC4 unit from main supply
(pull the plug out the socket). Screw off
the two screws of the handle on the top. Go on screwing off the six screws at the bottom of the unit.
Finally screw of the two screws of the fluid tank bracket for easier handling (see picture 4a). It’s not
necessary to screw off the feet of the ENTERPRISE TC4.
Picture 4a: Bottom of the ENTERPRISE TC4 unit
Take off the lid and disconnect the yellow/green cable (spanner size 7mm). Locate the PCB
ENTERPRISE TC4 board.
Picture 4b: Open ENTERPRISE TC4 unit
12
ENTERPRISE TC4 – SERVICE MANUAL
SMOKE FACTORY
FOG & HAZE GENERATORS
