6. Remove the drawbar.
7. Extend the mill spindle to expose the outer taper drift slot.
8. Rotate the spindle to align outer and inner taper drift slots. You will be able
to see the end of the adapter through both slots.
9. Insert the drift in the slot.
10. Holding the adapter with one hand, use a non marring hammer (rubber,
dead-blow, or brass) to drive the drift into the slot. The taper on the tool will
release and the adapter drop out.
Cutters mounted in the spindle must fit accurately. There are two ways to
make sure they do. For small cutters, fit the shank of the arbor that carries
the cutter directly into the taper hole at the end of the spindle. A drawbar
holds the arbor in place. For large cutters, bolt the cutter directly to the end
of the spindle.
Ordering Machining Accessories:
To order machining accessories for
your MI-409MZ mill refer to the accessories section of the website at
www.detroitmt.com
.
30
Summary of Contents for MI-409MZ
Page 1: ...Smithy MI 409MZ Operator s Manual 1 ...
Page 31: ...Chapter 13 Parts Diagrams in work ...
Page 32: ...Chapter 14 Electrical Diagrams ...
Page 33: ......
