ProgrAmming / seT-uP seQuenCe
ConTinuous DeliVerY
batteries must be installed; pump must be stopped and in ll0.
noTe: Value not saved is displayed if a value is scrolled and enTer/
CleAr is not pressed. Press neXT to continue programming.
WArning: if the pump is dropped or hit, inspect it for damage. Do
not use a pump that is damaged or is not functioning properly.
enter Dose
Cycle
enter reservoir
Volume
enter
Continuous rate
Clear milliliters
given
Verify Air Detector
status
Verify upstream
sensor status
Verify Programming
main screen
enter reservoir
Volume
enter Dose
Volume
enter Dose
Duration
main screen
enter KVo rate
Verify Dose
remaining
Press NEXT.
1. Press
´
or
Î
to select desired
reservoir volume.
2. Press ENTER/CLEAR.
3. Press NEXT.
4. Press
´
or
Î
to select desired
Continuous Rate in ml/hr.
5. Press ENTER/CLEAR.
6. Press NEXT.
WArning: This pump delivers medication at a
continuous rate or intermittent rate in milliliters
per hour (ml/hr). Programming the pump at a
delivery rate other than what is prescribed will
cause over- or under-delivery of medication.
7. Press ENTER/CLEAR to clear the given
value. The display will show 0.00.
8. Press NEXT.
9. Verify the setting is correct. (To change
setting, see Biomed Functions section.)
10. Press NEXT.
11. Verify the setting is correct. (To change
setting, see Biomed Functions section.)
12. Press NEXT.
13. Press NEXT repeatedly to review program.
inTermiTTenT DeliVerY
batteries must be installed; pump must be stopped and in ll1.
Press NEXT.
1. Press
´
or
Î
to select desired
reservoir volume.
2. Press ENTER/CLEAR.
3. Press NEXT.
4. Press
´
or
Î
to select desired dose volume.
5. Press ENTER/CLEAR.
6. Press NEXT.
7. Press
´
or
Î
to select desired dose duration.
8. Press ENTER/CLEAR.
9. Press NEXT.
10.Press
´
or
Î
to select desired dose cycle.
11.Press ENTER/CLEAR.
12.Press NEXT.
13.Press
´
or
Î
to select desired KVO rate.
14.Press ENTER/CLEAR.
15.Press NEXT.
note: Appears only during dosing or if dose is
interrupted.
16. Press NEXT.
17.Press
´
or
Î
to select amount of time
before next dose. Select IMMEDIATE if dose
should begin when pump is started.
18.Press ENTER/CLEAR.
19.Press NEXT.
20.Press ENTER/CLEAR to clear the given
value.
The display will show 0.00.
21.Press NEXT.
enter Dose
starts in
Clear milliliters
given
