16
Operation
INITIAL PROGRAMMING OF CONSOLE COMPUTER
When you first turn on Console power, after all installation procedures have been completed, the Console will
flash “CAL” in the RATE display and “US” in the DATA display. This means you must “calibrate” or program the
Console before it can be operated.
(This is a one time operation which does not have to be repeated unless you disconnect your battery wires.
Turning OFF the POWER ON/OFF switch does not affect the Console memory. All data is retained). The follow-
ing steps must now be followed.
If an entry selection error is made during steps 1, 2, 3, or 4, the Console can be reset by depressing
for
20 seconds (Data displays US and RATE displays CAL.).
1. Displaying US, SI or TU
a. Depressing momentarily
Steps the DATA display from US (acres) to SI.
b. Depressing momentarily
Steps the DATA display from SI (Hectares) to TU.
c. Depressing momentarily
Steps the DATA display from TU (1000 sq ft) to US.
2. Selecting US, SI or TU
a. To select US, SI, or TU, step
until the desired code is displayed in DATA display.
b. Momentarily depress
the DATA display will now display SP1.
3. Displaying SP1 or SP2
a. Depressing momentarily
steps the DATA display from SP1 (wheel drives, etc.) to SP2.
b. Depressing momentarily
steps the DATA display from SP2 (radar sensor) to SP1.
4. Selecting SP1 OR SP2
a. To select SP1 or SP2, step with
until desired code is displayed in DATA display.
b. Momentarily depress
the DATA display will now display 0.
5. Enter width in inches (cm) of BOOM 1 in the key labeled:
6. Enter width in inches (cm) of BOOM 2 in the key labeled:
If there is only one boom, enter "0" for
width of BOOM 2.
7. Enter width in inches (cm) of BOOM 3 in the key labeled:
If there is only one or two boom, enter “0”
for width of BOOM 3.
Summary of Contents for spray star 1008
Page 39: ...37 Reference ...
