14
Operation
CONSOLE PROGRAMMING
When entering data into the Console computer, the entry sequence is always the same. Data must be entered
into the first eight keys.
1. Depress the key which you wish to enter data.
2. Depress the “Enter” key. An “E” will illuminate
in the DATA display.
3. Depress the keys corresponding to the
4. Complete the entry by again depressing the
number you wish to enter (i.e. “5”, “7”, “2”).
“ENTER” key.
The numbers will be displayed in the DATA
display as they are entered.
CONSOLE CALIBRATION
CALCULATING “BOOM CAL” (BOOM 1, BOOM 2, BOOM 3)
Calculate the width of each boom in inches (centimeters) by multiplying the number of tips times the spacing.
Write these boom widths down for future reference when programming the Console computer. The Console is
capable of controlling up to three (3) booms.
CALCULATING “SPEED CAL"
1. Enter Speed Cal in key
of 612.
2. Place Master and Boom 1 switches to on.
3. Enter “0” in key
.
4. Drive 1 mile. Do not use vehicle odometer to determine distance, use section lines or highway markers.
5. It should read a value of approximately 5280. If it reads between 5200-5350, the Speed Cal for this vehicle
is 688.
If the Distance display reads any other value, divide Speed Cal by the value observed in Distance, then
multiply by 5280. This will give you the correct value to enter for Speed Cal. You must round off to the
nearest 3 digit number (use 120 not 120.3).
Summary of Contents for spray star 1008
Page 39: ...37 Reference ...
