11
12
smithandnoble.com
800.248.8888
Step 2 — Mounting Brackets
Outside Mount
First, hold the shade above the
window so that it’s perfectly centered
over the window opening at the
desired height . Mark the position of
the bracket on the wall . End brackets
should be located 2" from each end .
Mount the brackets to the wall . Make
sure the mounting brackets are level .
If needed, space additional brackets
evenly between two end brackets .
Battery Pack Mounting
A
ttach the pack clips to the headrail as
pictured .
Then press the battery into place .
Extension Brackets (optional)
Optional Extension Brackets are used
to project the back of the shade up
to 2
1
⁄
2
" from the mounting surface .
Attach the Standard Mounting Bracket
to the Extension Bracket with the nut
and bolt provided .
Extension
Bracket
Wall mount -
attach the wand
clips with the
screws provided. If
necessary, remove
shade to mount the
clips in the desired
location.
UltraSleek Plus
Deluxe
Pack Clip
Shade
Headrail
Mounting
Brackets
2"
Step 3 — Attaching the Power Source
Wall mount -
attach the wand
clips with the
screws provided. If
necessary, remove
shade to mount the
clips in the desired
location.
UltraSleek Plus
Deluxe
Attaching the Transformer
Plug the transformer wire into the motor
wire . Secure the wire behind the shade
and along the window casing as required.
Plug the transformer into an electrical outlet .
If the wire is not long enough to reach,
optional 48” extension wires are available.
Attaching the Power Source
When attaching the Power Source to
the Battery Pack, first plug the battery
pack wire into the motor wire .
Noting the length of the wire, determine
the best location for the battery pack . The
pack may be mounted to the window
casing, the wall or behind the fabric
roll (if space permits) . Before mounting
the pack make sure that the pack and
excess wire will not interfere with the
operation of the shade . Extension wires
are available if needed .
Battery Pack
Battery Wire
Motor Wire
Attach and twist
clockwise until tight
(do not overtighten)
To Solar Panel
To Motor
Hanging the Shade
Insert the rail into the opening of the
bracket . Push the rail back until it is
fully engaged .
Removing the Shade
To remove the shade, partially lower the
shade and insert a flat head screwdriver
as shown . Twist the screwdriver until the
headrail disengages from the bracket .
To remove the shading, partially lower the
as shown. Twist the screwdriver until the
headrail disengages from the bracket.
UltraSleek Plus
Deluxe
Step 4 — Hanging the Shade
