19
20
smithandnoble.com
800.248.8888
Operating the Controls
Optional
Hold Down Bracket
Optional Hold Down Brackets are
mounted with the supplied screws .
With the shade at its proper drop, place
the pin of each Hold Down into the hole
in each End Cap and make sure the pins
are level and aligned. Raise the shade,
then screw the Hold Down Bracket into
the mounting surface .
Skew Adjustment
If the shade does not raise evenly, first
make sure the mounting brackets are
mounted level with each other .
If the shade is level and it still skews,
operate the shade to the full down
position . Prepare a strip of masking
tape approximately 5” long. On the
side of the shade opposite of the
skewing direction, and as close to the
end of the roller as possible, lift the
fabric toward the back of the shade
using your fingers and slide the tape
with the sticky side facing the roller up
as far as possible . The tape is to be
running parallel to the roller .
Roll the shade up and check for
skewing. If the shade is still skewing,
add another strip of tape on top of the
first one. If the shade is now skewing in
the opposite direction, tear off about 1”
of tape from the last strip installed . The
tape is to be torn from the end closest
to the center of the shade .
If these suggestions don’t work, then
please give us a call or visit our website.
Remote Control
Select the desired channel with the
CHANNEL key . The channel indicator
light will illuminate the channel that in
on. If all 5 lights are lit, the remote will
control all 5 channels at once .
Tapping the UP or DOWN keys for less
than 2 seconds will move the shade in
short steps . Holding the UP or DOWN
keys down for more than 2 seconds
before releasing, will operate the shade
in the faster standard speed .
Press the UP or DOWN keys to raise or
lower the shade .
Press the STOP key to stop the shade
anywhere along the window .
Refer to the Motorization Guide for
additional details.
Wand Controls
Touch & Go Feature:
To fully raise or lower the shade, simply
press the UP or DOWN button for 2
seconds and release . The shade will
automatically stop when it reaches
the upper or lower limit .
(See the
Motorization Guide if the upper or lower
limits are not set at the desired positions)
Tapping the UP or DOWN keys for less
than 2 seconds will move the shade in
short steps . Holding the UP or DOWN
keys down for more than 2 seconds
before releasing, will operate the shade
in the faster standard speed .
Press the DOWN or UP button to lower or
raise the shade . Press the opposite button
to stop the shade at the desired position .
Refer to the Motorization Guide for
additional details.
Channel
Display
Up
Stop
Down
C
Channel —
1
2
3
4
5
Up
Down
FABRIC ROLL
PLACE TAPE AT THIS END
