25
10
CHOSING THE PROGRAM
Scrolling through the programs available displays first the program name (in English) and hen the number
(P1, P2….. etc.) followed by the duration.
PROGRAM
TYPE OF DIRT
DURATION (*)
GLASS Short
P1 Dirty soiled glasses
1 min
Glass Medium
P2 Normally soiled glasses
1 min 20s
GLASS Long
P3 Heavily soiled glasses
2 min 30s
CUSTOM Program User
P4 Customisable (see "set-up information")
1- 10 min
DISHES Short
P5 Lightly soiled plates
1 min
DISHES Long
P6 Heavily soiled plates
1 min 30s
Cutlery
P7 Intensive programm with 70°C washing
4 min 10s
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and
recommended in the "TECHNICAL DATA" table, and in all cases refers to the first cycle performed. For
repeated cycles, operating conditions may vary from installation to installation. If the dishwasher is
supplied with cold water, the cycle duration might increase depending on the intake water temperature
and the "thermostop" setting.
Power blackouts.
If the dishwasher is open when power is restored, the display will read “
°
t
” and the heating
element will remain off, to prevent the risk of burns to the user.
Close the dishwasher to resume heating the water in the tank.
Enabling/disabling the program name on the display
The display shows the program number P1, P2, P3 and name, Glass, Dishes, Cutlery etc. by default. You can
choose not to display the name of the program. In this case, only P1, P2, P3 etc. will be shown on the
display.
The procedure must be carried out with the machine switched off but powered.
Press and hold down the start / pause button.
When the vertical lines ||||| appear on the display, release the start / pause button and then press it
again immediately.
The procedure is complete; there is no audible or visual confirmation.
It is possible to check if the procedure has been carried out correctly when the machine is switched on
again.
