17
"Clean water" cycle
When this option is activated, the appliance pumps out all
the water from the tank and then refills it with clean water
at every wash cycle. How long this operation takes depends
on the washing water temperature.
On: enabled – OFF: disabled.
N.B.: prolonged use of this option leads to higher detergent
and rinse aid consumption.
Thermostop
Set as “on” = minimum rinsing temperature as set, (see
boiler temperature above) regardless of intake water
temperature; the cycle duration may be a few seconds
longer than the nominal length.
Set as “off” = the minimum rinsing temperature might be a
few degrees lower than the setting if hot intake water is not
used.
If the thermostop device is set “off” the rinsing °
t
are no longer monitored and the user is
responsible for ensuring that the minimum correct °
t
are maintained for the tank and boiler. It is
particularly important to check the intake water temperature.
Also refer to the insufficient washing/drying /foam in tank point of the “troubleshooting” section :
restore °
t
Stop ON and/or connect the appliance to a hot water supply.
High speed (FST) or economy (ECO) filling (FILL)
Fast start (FST): starts the dishwasher in less than the
standard time; leads to higher water consumption for the
first cycle start.
Eco start (ECO): starts the dishwasher in standard time, with
no added water consumption.
On: enabled – OFF: disabled.
Cycles performed counter
Shows the count of the total cycles performed by the
dishwasher since installation.
This parameter cannot be modified or reset unless the
software is reprogrammed.
