Instructions for the installer
22
2.2
Positioning the adhesive sponge
Carefully position the adhesive
sponge (provided) on the outside
edge of the hob frame.
It will separate the frame surface
from the unit surface. The figure
to the right shows the correct
position of the sponge. Pay close
attention during positioning
to
ensure that it does not extend
past the outer edge of the
frame.
2.3
Positioning the fastening clips
Insert the fastening clips in each
of the positions indicated by the
arrows. The clips ensure that the
hob will be fixed and centred as
accurately as possible.
To install the clips into the hob, all
you have to do is insert them
horizontally into the appropriate
space by applying light pressure
(
fig. A
).
Then turn them upwards to fix
them in place (
fig. B
).
2.4
Inserting the hob into the hole in the work surface
Be very careful when inserting the hob. If the process is not followed correctly as
described, the hob may be damaged.
Before inserting it, remove the
racks (if they are mounted) and
burners from the hob.
Insert the hob, resting the frame
completely on the back edge of
the hole in the work surface. Do
not apply pressure to the frame as
this part is very fragile and could
be damaged.
Then lower the front of the hob
until it is fully inserted.
