Instructions for the installer
28
5.5
Re-assembling the hob top
Follow the instructions in “5.1 Removing the hob top” in reverse order.
When re-assembling the couvettes, check that the seals are positioned correctly.
Position the racks as detailed in
7.1Positioning the racks.
5.6
Adjusting the minimum setting for natural gas
Reposition the components on the burner and slide
the knobs onto the tap rods.
Light the burner and set it to the minimum position
.
Extract the knob again and turn the adjustment screw
inside or next to the tap rod (depending on the model)
until the correct minimum flame is achieved.
Refit the knob and verify that the burner flame is
stable (when turning the knob rapidly from the
maximum to the minimum position the flame must not
go out).
5.7
Adjusting the minimum setting for liquid gas
To adjust the minimum setting with liquid gas, you must tighten the screw inside or
next to the tap rod (depending on the model) fully in a clockwise direction.
The by-pass diameters for each individual burner are given in “5.2 Adjustment for liquid
gas”.
After adjustment with a gas other than the preset one, replace the label on the casing
of the appliance with the label corresponding to the new gas. The label is located
inside the GPL nozzle pack (G30 – G31).
5.8
Arrangement of the burners on the hob
Type of burner
1 Auxiliary
2 Semi-rapid
3 Rapid
4 Ultra-rapid
5.9
Lubrication of gas taps
Over time the gas taps may become difficult to turn and get blocked. Clean them
internally and replace the lubrication grease.
This procedure must be carried out by
a specialised technician
.
