Manual GW4090 - User
Versione 22.10.08
39
25
NO PRESS IN HYD SYS: FOAM
Check the type of detergent used.
Repeat the cycle.
26 EVF
LEAKAGE
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
27 EVC
LEAKAGE
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
28
EVD LEAKAGE
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
29
WASHING CHAMBER DRAINAGE
FAILURE
Make sure that the drain pipe is
positioned as indicated in the manual.
30
SAFETY CHAMBER LEVEL EXCEEDED
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
31
SAFETY LEVEL FAILED
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
32 SUMP
FULL
Make a Reset cycle. Repeat the cycle.
Call the Technical Assistance Service
if the fault persists.
33
LACK OF WATER IN THE STEAM
CONDENSER
Check the water supply (cock
open/closed, water pressure,
connection pipe, etc.)
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
34
CONDENSER DRAINAGE FAILED
Make sure that the drain pipe is
positioned as indicated in the manual.
35
CONDENSER LEVEL SWITCH FAILED
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
36
CONDENSER DRAINING PUMP FAILED
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
37
NOT REACHED TARGET DRAINAGE AT
T=
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
38
COOLED DRAINAGE FAILED
Repeat the cycle. Call the Technical
Assistance Service if the fault persists.
41
DETERGENT 1 INFLOW FAILED
(flowmeter nr.1 optional)
Make sure that the suction tubes of can
P1 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
42
DETERGENT 2 INFLOW FAILED
(flowmeter nr.2 optional)
Make sure that the suction tubes of can
P2 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
43
DETERGENT 3 INFLOW FAILED
(flowmeter nr.3 optional)
Make sure that the suction tubes of can
P3 are in a good condition and not
squashed. Repeat the cycle. Call the
Technical Assistance Service if the
fault persists.
44
DETERGENT 4 INFLOW FAILED
Make sure that the suction tubes of can
P4 are in a good condition and not
