![background image](http://html.mh-extra.com/html/smc-networks/smcsm01-z/smcsm01-z_manual_1300625004.webp)
SMC Smoke Detector Guide
Copyright
©
2011 SMC Networks
Page 5
All Rights Reserved
8
Installation
I/M SMCSMXX-Z rev. 2.0
7/26/11
Note:
Add the SMC Smoke Detector to the
TouchScreen before physically mounting the
smoke detector in the desired location.
A.
Disconnect alarm-notification appliances,
service-release devices, and extinguishing
systems. Test communications between the
control panel and smoke detector before
permanently mounting the smoke detector
as follows:
-
Hold the smoke detector where you plan
to install it.
-
Press the smoke detector test button for
8-to-10 seconds. The smoke detector
sends a signal to the control panel.
-
At the control panel, verify the signal was
received and RF signal strength is
adequate. If no signal is received or the
RF signal is low, relocate the smoke
detector and retest.
B.
Using two supplied screws and anchors,
mount the base.
C.
Attach the smoke detector to the mounting
base as follows:
-
Line up the raised alignment tab on the
lip of the smoke detector with the arrow
on the mounting base.
-
Insert the smoke detector into the base
and turn clockwise about 15 degrees until
it snaps into place.
Note:
The smoke detector cannot be attached
to the mounting base if no batteries are
installed.
D.
Test communications between the control
panel and smoke detector again:
-
Press the Test button on the alarm for 8-
to-10 seconds. The smoke detector sends
a signal to the control panel.
-
Verify that the signal at the control panel
was received.
E.
Test the smoke detector (see section 9).
F.
The control panel alarm and all auxiliary
functions should be verified for a complete
test of the system.
9
Testing and Maintenance
¾
If a Low battery notification appears on the
TouchScreen, follow the instructions under
“Replacing the Battery” on page 6.
Maintaining the SMC Smoke
Detector
The SMC Smoke Detector requires occasional
maintenance. An alert on the TouchScreen
indicates when to perform maintenance. The
Alignment Arrow
Alignment Tab
table below shows notification messages the
TouchScreen may show for a smoke detector.
If a
¾
CleanMe notification appears on the
TouchScreen, follow the instructions under
“Cleaning the SMC Smoke Detector” on page
7.
¾
If a Maintenance alert notification appears
on the TouchScreen, follow the instructions
under “Sensitivity Testing” on page 6.
Signal
Meaning
CleanMe
Smoke detector sensitivity is out of range
and needs cleaning.
Maintenance
alert
Smoke detector failed power-up self test.
Perform a sensitivity test (see “Maintaining
the SMC Smoke Detec” on page 6). If
problem persists, replace smoke detector.
Low battery
Batteries are low and must be replaced as
soon as possible.
continued on next page